unexpected behaviour when building along path

Comments

2 comments

  • Dale

    Hello Bjorn,

    This is an unusual extrusion path that PB is struggling with .  It is a type of self-intersecting joint. The problem is probably being magnified by the large number of segments for your arcs.  Is there any way you can simplify your arc?  You may get better results if you have less arc segments.

    0
    Comment actions Permalink
  • Björn Ipsen

    if i simplify the arcs for example with edge tools, the result gets better but still not perfect. The arc is also not looking good anymore because there are too less segments for a curve. In profile builder version 2 i had no problems with these kind of curves. There were only few problems when the shape got too small but the c shape you see above is 1800 mm in height

    0
    Comment actions Permalink

Please sign in to leave a comment.